Challenges and Solutions in Design and Fabrication of Finger Prosthesis

Authors

  • Ranajit Chakraborty Mechanical Engineering Department, Dr. B. C. Roy Engineering College, Durgapur, West Bengal, India
  • Soumyo Chakroborty Mechanical Engineering Department, Dr. B. C. Roy Engineering College, Durgapur, West Bengal, India
  • Buddhadev Das Mechanical Engineering Department, Dr. B. C. Roy Engineering College, Durgapur, West Bengal, India
  • Chandan Chattoraj Mechanical Engineering Department, Dr. B. C. Roy Engineering College, Durgapur, West Bengal, India

DOI:

https://doi.org/10.55529/jecnam.33.12.19

Keywords:

Finger Prosthesis, Design, Fabrication, Rehabilitation, Grasp Pattern.

Abstract

The finger is important for its function and appearance. Finger loss causes functional and mental health issues. Finger prostheses are frequently not very long-lasting. It must be changed on a regular basis because frequent insertion and removal could cause permanent damage or discoloration. There are numerous clinical and laboratory stages involved in the production of a new finger prosthesis, which takes time. Complex adjustments need to be made during the delivery visit even after the finger prosthesis has been made to ensure a secure fit and the right marginal adaptation.

Downloads

Published

2023-04-03

How to Cite

Ranajit Chakraborty, Soumyo Chakroborty, Buddhadev Das, & Chandan Chattoraj. (2023). Challenges and Solutions in Design and Fabrication of Finger Prosthesis. Journal of Electronics, Computer Networking and Applied Mathematics, 3(03), 12–19. https://doi.org/10.55529/jecnam.33.12.19

Issue

Vol. 3 No. 03 (2023): April-May 2023

Section

Articles

License

Copyright (c) 2023 Authors

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.